Magic Tricks

A lot of reviews gave this 1 or 2 stars is because the thread “breaks” very easily while preforming , and that because of the HOLE ( it has a sharp edges ) that when the thread hits the edges of the hole , it’ll break immediately ...
I HAVE A SOLUTION FOR THIS 💡
Step 1 : take the thread out of the TUBE and keep it on a side.

Step 2 : take the TUBE and a LIGHTER , and just BURN the hole ( just a little bit ) you don’t need to melt the plastic , and then the sharp edges will GONE .

You have to try this method 👌👌👌